Oozing Goo - The Lava Lamp Syndicate

I was wondering if anyone knew a good method to add fluid to lamps with slightly low water levels. I have one lamp in particular that is about 1/2 inch lower than it should be. Other than that, it looks and works great. Can I just put some distilled water in? Won't that change the balance of the existing fluid or would I have to add something else? Thanks!

Views: 3796

Reply to This

Replies to This Discussion

it depends what make the lamp is. I believe if it is a LW/LL lamp then you can add a little distilled water to top it up. as its not much you'd be adding i think that would be fine. but the age of the lamp may also make a difference to the forumlas used so this is not 100% to go on.
if it is a crestworth or mathmos then it isnt advisable as the formulas are different.
the difference it would make to the LW/LL lamp is it may affect the gravity of the fluid a bit which i believe can be corrected but if i were you i would wait for other replies as I dont want you to f*** up your lamp cos I said so!
:)
The old 60s Crestworths and Lava Lites could be topped up with distilled water. I'm not sure about others. If the loss is due to evaporation, only the water evaporates. If it's due to other causes and actual complete liquid has been removed, adding water will throw off the balance.
If its a china lamp you can use water. If its an older usa lamp use propylene glycol. This way you wont change the densities.

Assuming it's a 1978 century... and assuming about an inch to an inch and a half of distilled water was added... how would one go about correcting the densities? I just did it last night (before reading this post) and now my goo just forms a large blob that hovers in the center with no flow. It looks cool, but I miss the old flow :-/ my issue was that I didn't like the space between the cap and the top of the liquid so I filled it to that line. I did add a drop of gookit surf but I figured I'll wait for some replies before I do too much more to it lol

I'm in the process of tweaking and restoring and while I've had decent results using Epsom salts and distilled water, to make a specific gravity of ~1.3 using the original goo, I think it is more complex than just topping up.

Consider that the original fluid and wax probably had carbon tet or perc in it. Even when mixed in wax, that stuff is more volatile than water and at room temperature, it should evaporate out of the lamp first, and faster.

So if your lamp is down an inch or two....what boiled out before any water did? Right, the carbon tet or perc. Possibly form the wax, not just from the fluid.

I've researched this and don't find anything on point about it. I plan to explore it slowly in weeks ahead.

But if you just want to add fluid...I'd check the specific gravity first, try to keep it where it is, if the goo moves in a way that you like right now. Change the sg and the goo will behave differently! A very small change can make it sink, or stay at the top, with no motion at all.

Reply to Discussion

RSS

About

Mark Goo created this Ning Network.

Support Oozing Goo

By using the eBay button above, you support OG if you purchase anything. Thanks for thinking of us. Mark Goo

© 2022   Created by Mark Goo.   Powered by

Badges  |  Report an Issue  |  Terms of Service