Oozing Goo - The Lava Lamp Syndicate

Ulcer on the belly of the beast!

Views: 232

Comment

You need to be a member of Oozing Goo - The Lava Lamp Syndicate to add comments!

Join Oozing Goo - The Lava Lamp Syndicate

Comment by VOXul on December 16, 2014 at 3:23pm

You and I both! All ups and downs of the process will be on display here. To no DOWNS until it is on the base once again!

Comment by MileHigh on December 16, 2014 at 1:09pm

I hope the Wave Machine gods are merciful and you only have one drink! 

Comment by VOXul on December 16, 2014 at 12:58pm

That is my thinking too, it will be out of sight, man was It a heart breaker of a discovery. I think the long crack should weld up pretty good and hopefully I can salvage-lift the serial number sticker so that it can be laid back down and kept original. My worry is that little connected tooth-shaped crack off to the left. I have a feeling any attempt to pull the plug will cause that little chunk to bust off in its current condition :(

I have ordered some solvent cement and have a game plan. Initial sealing of the long crack and upper/corner area of the tooth crack, let it bond and seal. Then very carefully try to extract the plug, have a drink with success two drinks with failure. Proceed to cement all areas of those lil guys with the plug off, purchase Lava fluids, top her off and figure out how to get that lil devil plug back in, haha.

Upon completion sit back and add an umbrella to the drink and stare, maybe drool a bit.

Comment by MileHigh on December 16, 2014 at 12:44pm

That crack sucks. :(

At least it is located in the best possible area.

You will not be able to see it when the vessel is on it's base. :)

About

Mark Goo created this Ning Network.

Support Oozing Goo

By using the eBay button above, you support OG if you purchase anything. Thanks for thinking of us. Mark Goo

© 2022   Created by Mark Goo.   Powered by

Badges  |  Report an Issue  |  Terms of Service