Oozing Goo - The Lava Lamp Syndicate

Ulcer on the belly of the beast!

Views: 232

Comment

You need to be a member of Oozing Goo - The Lava Lamp Syndicate to add comments!

Join Oozing Goo - The Lava Lamp Syndicate

Comment by Carol on February 21, 2015 at 4:17pm

Cant wait!!!!!

Comment by Critter on February 21, 2015 at 2:49pm
Counting down with you!
Comment by VOXul on February 21, 2015 at 2:35pm

UPDATE: ETA to ROCKIN' THE BOAT, T-minus 3ish hours

Comment by VOXul on February 7, 2015 at 2:02pm

AHAHA! I was waitning for someone to call it out, Pete! I can say this machine is being one at the moment

Comment by Aladdin 2 Lava on February 7, 2015 at 6:34am

Looks a bit like a Willy !!!!

Well someone had to say it.... ha ha hee hee...........

Comment by VOXul on February 6, 2015 at 10:46pm

UPDATE: I have an empty Pacifica, tomorrow I baste it!

Comment by Aladdin 2 Lava on January 30, 2015 at 6:47pm

Oh no nick... that's not feking fair !

Comment by Carol on January 28, 2015 at 9:04pm

omg, I totally wrecked my pink kit trying to get out that ghetto lint filter, lol!!!!  I started stirring around too much with the coat hanger to try and catch it and I mixed water with the lava.  Even after the boil down, I had to trash the lava because it was like a sludge/slurpee even when ice cold!!  I redid a whole new pink kit and although I do miss the ability for the old one to sometimes turn clear, it flows much better now.  I did reuse the lint filter coil idea, but I cut it and thinned it out to more of the size of an original coil and it flows pretty decent!!  I hope you have the same luck with the pacifica vox!!!!  fingers crossed!!!

Comment by VOXul on January 28, 2015 at 5:13pm

Thanks Pete, I am going to need it as things go.

UPDATE: After getting the vessel all prim and proper I noticed that there was a weird foam in between the two fluids. Spoke with Torrey and he said that the method to fill it back up may have put the surfactant under too much pressure causing it to basically explode itself into a strange foam that doesn't know what fluid to bond with. The recommended steps are to drain the entire vessel into a bucket and use a turkey baster to remove the confused liquid. I have noticed that the foam seems to be dissipating slowly (might all be in my head though) but it still contains some of it

Slow and steady wins the race. After catching a glimpse of this thing in action, before discovering the foam, I am hungry for a lot more. While the foam adds a bit of realism to an actual ocean break it will eventually cause mass chaos inside if it is left inside. My Pacifica duties at this point are to get a container for the fluid, a length of micro fuel line to start a siphon and a turkey baster. I am hopeful that I will fix it but the lingering idea of it being a wounded soldier is still in my head. DON'T PUT YOUR FLUIDS UNDER PRESSURE OR SHAKE THEM!

Comment by Aladdin 2 Lava on December 17, 2014 at 11:43am

Everything's crossed for ya Nick !

About

Autumn created this Ning Network.

GooHeads

Groups

© 2024   Created by Autumn.   Powered by

Badges  |  Report an Issue  |  Terms of Service