Oozing Goo - The Lava Lamp Syndicate

The oldest "OPTIC LAMP MOD. ASTRO" RGB LED Mood Light Or Rainbow lighting conversion.-2

Continues...

There is no fixing piece at the bottom. So I threaded.

I checked the PWM circuit, which I had previously done for another study, but not using.

The diameter of the hole where the spray is attached is almost the same as the diameter of the lens of the led.

However, the lens a bit loose. Adhesive tape is wrapped around it.

Now OK

It comes to the preparation of the 12 volts power supply. It was also made in the diode bridge circuit.

Later electronic circuit is drilled and cut for installation. Objective to preserve the originality of the lamp.

I don't know what it's called. Is cable protection correct?

Cable protection is installed in the hole where the cable comes out. (Original has no cable protection, installed for safety.)

 

Installation

All parts are installed in their places.

Even unused old ones are attached so that they can come back again.

First run

The camera cannot fully deliver the colors. It has been running for four hours. When it gets dark, I will cover it and install the spray.

https://oozinggoo.ning.com/video/test

Views: 211

Latest Activity

IdOrU 02 posted a discussion
14 hours ago
Andrew Black is now a member of Oozing Goo - The Lava Lamp Syndicate
Saturday
Craig Van Mackelberg replied to Craig Van Mackelberg's discussion Fantasia Cosmos 5000 Lamp
Jul 15
Craig Van Mackelberg posted a discussion
Jul 15
Katy is now a member of Oozing Goo - The Lava Lamp Syndicate
Jul 15
KittenChops posted a discussion
Jul 12
Aisling Silva is now a member of Oozing Goo - The Lava Lamp Syndicate
Jul 10
Teddy Wulftone posted a blog post
Jul 7

GooHeads

© 2025   Created by Autumn.   Powered by

Badges  |  Report an Issue  |  Terms of Service