How to change Goo Kit flow

[Katsushirou15]

Hello OG, This is my first post but I have been reading the forums as a guest for a while. I finally decided to join the OG community. I have created my first Goo Kit lamp. The flow is a little too slow for me and I want the goo to split off more. I used about 70 mL of the surfactant and only distilled water. What can I do to increase the flow rate and the amount of blobs in my lamp? This is my second run of the lamp. I also have Epsom salt if it is needed. My Grande is also using the two coils that it came with as well. I have a dimmer but I am running it on max and I still don't have much activity. Any help is greatly appreciated.

[Keith]

I would suggest letting the globe cycle through several runs before making any changes.  This will give the wax a chance to break in.

[Katsushirou15]

Okay I'll let it cycle for a week and see if the flow changes. Thanks Keith.

Keith said:

I would suggest letting the globe cycle through several runs before making any changes.  This will give the wax a chance to break in.

[Shelley warne]

Why did you regoo, how did you regoo and how old please

[Tim Gill]

I personally think its fine, it looks really good
Cycle it for a while and see how it goes - adding a touch more surf should sort it out.

[Katsushirou15]

So I have been cycling my lamp on full power for a few days now and I noticed that there is a layer of wax that has stuck on the bottom of my globe. Did my wax get burnt by running the lamp at full power or I did not clean my globe enough before I did the kit? I suspect that the stuck wax may be affecting the flow somehow. Any help is appreciated.

[Brad]

hey, not sure how you filled the globe with water, but it helps to mix the surfactant with the water first, then pour the solution into the globe.  dr. what has a nice write up on this forum if you search for it.  i would look but i'm zzzz

welcome to OG!

[Katsushirou15]

I followed the Goo Kit tutorial and I coated my globe with the surfactant/water mix before I added the wax. I'm not sure if some else happened which caused the wax to stick on the globe.
Brad said:

hey, not sure how you filled the globe with water, but it helps to mix the surfactant with the water first, then pour the solution into the globe.  dr. what has a nice write up on this forum if you search for it.  i would look but i'm zzzz

welcome to OG!

[Tim Gill]

what kind of coil are you using - the gookit mesh one or the one from the grande.

[Katsushirou15]

I am using the two coils that came with my grande. One large coil and one small coil.
Tim Gill said:

what kind of coil are you using - the gookit mesh one or the one from the grande.