Oozing Goo - The Lava Lamp Syndicate

Hello all, first time here.

I have an old lamp that was my grandma's and I'm a little sentimental about it.  It must be early 70's minimum because I remember it as a child.  I'm sure you all can probably identify it and that might help what I'm trying to do here.  A few years ago the cap cracked, it got cloudy and didn't work good anymore.  I'm in the process of trying to restore it, using the lava formula I found here.  I was about to say goodbye to it because I could not find a replacement cap.  Then I realized I could 3D scan the old cap, use that to build it in CAD, and have a replacement 3D printed!  So the cap should be back from the printer soon and hopefully it fits and the re-lava goes well.  I want to share the file used for the 3D print, it took about 10 hours and some pretty expensive equipment/software to reverse engineer.  The cap only cost $13 to print once I made the file.  I do want to make sure my replacement fits before I upload it.  I will also try to give updates on my overall success with the restore.  Here is a picture of the lamp so maybe someone can identify it.  Hard to tell in picture but it is gold-ish in color, and the cap screws onto the glass threads with an o-ring seal.

Buy it here https://www.shapeways.com/product/4TJ6AR66D/lava-cap-for-70-s-quot-...

Views: 3472

Reply to This

Replies to This Discussion

You were with support at the beginning @Claude J  It's great to see you found a good original color also.  I'm not around often, but I'll be around again!

thumbs up

Reply to Discussion

RSS

Support Oozing Goo

By using the eBay button above, you support OG if you purchase anything. Thanks for thinking of us. Mark Goo

© 2021   Created by Mark Goo.   Powered by

Badges  |  Report an Issue  |  Terms of Service